...
Answer the questions - some data will may be populated from the data in the patient patients clinical record
The first mandatory question - ‘'Did the patient DNA’' must be answered and then select if you would like to generate a patient plan
All mandatory questions will be labelled in red
Results that are out of date will be highlighted in red
Values that are out of range will be highlighted in red
As the questions are answered different options may appear
Calculators are indicated by a green square, click on the square to open the calculator if the result has not populated
When all the required values have been populated clicking on ‘calculate’ will perform the calculation
The result of the calculation will be displayed
Once all the mandatory questions have been answered the Finish button will be enabled
Throughout the review, the Clinician will be able to see the patient details and any other available tabs - Heart Age Calculator, Documents to Print and Visualisations.
The Heart Age Calculator tab is populated with data entered during the Health Check but these values can be altered in the tab to show the effects of lifestyle change on the QRISK score. No data collected in the Health Check will be affected by changing the information in the Heart Age Calculator.
Any documents produced by the Health Check (e.g. the patient plan) will be available to be printed on the Documents to Print tab
For a completed Health Check print the documents BEFORE you click on Finish
Once the documents have been printed click on the Finish button
Review the codes that will be added to the patient record
Unticking the boxes against the code lines will stop that code being saved to the patient record
Clicking on Add Codes at the bottom of the screen will save the selected codes to the patient record
Once you see the message:-
close the Health Check Template tab at the top by clicking on the X as the Health Check is complete
NOTE: If you see a warning that codes have not been saved
Check that you are logged in to the Principal Clinical System - as mentioned above
Check that the Skyline Desktop Connector is logged in - as mentioned above
...