Page Comparison

...

• Answer the questions - some data may be populated from the data in the patients clinical record

• The first mandatory question - ‘'Did the patient DNA’' must be answered and then select if you would like to generate a patient plan

• All mandatory questions will be labelled in red

• Results that are out of date will be highlighted in red

• Values that are out of range will be highlighted in red

• As the questions are answered different options may appear

• Calculators are indicated by a green square, click on the square to open the calculator if the result has not populated

  • When all the required values have been populated clicking on ‘calculate’ will perform the calculation

  • The result of the calculation will be displayed

• Once all the mandatory questions have been answered the Finish button will be enabled

• Throughout the review, the Clinician will be able to see the patient details and any other available tabs - Heart Age Calculator, Documents to Print and Visualisations.

  The Heart Age Calculator tab is populated with data entered during the Health Check but these values

  The Visualisation tab will appear and display data once the minimum data requirements are met

  • Values can be altered in the tab using the slider to show the effects of lifestyle change on the QRISK score. No data collected in the Health Check will be affected by changing the information in the Heart Age Calculator.Any visualisation tab.

• Once all mandatory fields have been populated a Health Check Completed box will be displayed - tick Yes

• The "Tick to generate patient plan" box must be ticked to produce a patient plan

• The Documents to Print tab will list any documents produced by the Health Check (e.g

  .

  the patient plan) will be available to be printed on

  the Documents to Print tab

  • For a completed Health Check print the documents BEFORE you click on Finish

• Once the documents have been printed click on the Finish button

• Review the codes that will be added to the patient record

Unticking the boxes against the code lines will stop that code being saved to the patient record

• Print the documents

• Clicking on Finish will prompt to confirm completing the Health Check and adding the codes

  • Click on Yes to accept the statement

  • Check you’re happy with the codes being added into the clinical system

  • Clicking on Add Codes at the bottom of the screen will save the selected codes to into the patient recordpatients clinical record

  • A confirmation message will be displayed

    Image Added

  • Once you see the message :-

    Image Removed

    close the Health Check is complete

    • Close the Health Check Template tab

    at the top

    • in your Internet browser by clicking on the X as

    the Health Check is completeImage Removed

    • shown below

      Image Added

       

  • NOTE: If you see a warning that codes have not been saved

    

    • Check that you are logged in to the Principal Clinical System - as mentioned above

    • Check that the Skyline Desktop Connector is logged in - as mentioned above