...
Did the patient DNA - by ticking NO to the question, the Health Checks template will be displayed
The box "Tick to generate patient plan" will be ticked as default
Answer the questions - some fields may be populated with the data held in the patients clinical record
Mandatory questions will be labelled
Values that are out of range will also generate an error message
As the questions are answered different options may appear
Calculators are indicated by a green square, click on the square to open the calculator if the result has not populated
When all the required values have been populated clicking on calculate will perform the calculation
The result of the calculation will be displayed
The Visualisation tab will appear and display data once the minimum data requirements are met
Values can be altered in the tab using the slider to show the effects of lifestyle change on the QRISK score. No data collected in the Health Check will be affected by changing the information in the visualisation tab.
The Documents to Print tab will list any documents produced by the Health Check (e.g the patient plan) will be available to be printed on
Print the documents
Once all mandatory fields have been populated a Health Check Completed box will be displayed - you MUST tick Yes YES
| Note |
|---|
Failing to tick the Health Check completed box will result in the Health Check Done code NOT being generated. |
Clicking on Finish will prompt to confirm completing the Health Check and adding the codes
Click on Yes to accept the statement
Check you’re happy with the codes being added into the clinical system
Clicking on Add Codes at the bottom of the screen will save the selected codes into the patients clinical record
A confirmation message will be displayed
Once you see the message the Health Check is complete
Close the Health Check Template tab in your Internet browser by clicking on the X as shown below
NOTE: If you see a warning that codes have not been saved
Check that you are logged in to the Principal Clinical System - as mentioned above
Check that the Skyline Desktop Connector is logged in - as mentioned above